GHRP-6, and this applies to all GHRP hormones, mimic the production of ghrelin. This mode of action stimulates the ghrelin receptors, GHS-R1a or Growth Hormone Secretagogue. This stimulation acts to increase GH production by stimulating the pituitary, specifically the ghrelin receptors located in the pituitary.
Elevated ghrelin is also known to stimulate the appetite. Alternatively, the hormone will promote fat loss and more importantly enhance the rate of recovery. However, while ghrelin has been shown to promote recovery, in cases of GHRP-6 and elevated GH levels it is more likely that the corresponding elevated levels of IGF-1 play a larger role. IGF-1 levels will not spike at the rate comparable to direct Human Growth Hormone (HGH) use as the pulsating effect of GHRP-6 is short-lived.
GHRP-6 is also a hormone that is dependent on glucose, specifically when blood sugar levels are low. Elevated levels of blood sugar will render GHRP-6 weaker, meaning it must be taken during a fasted state for any intended benefit to be had.
DOSE AND RANGE OF USING
Standard cycle is 4-8 weeks ( for longer cycle, better tak a break of 1-2 weeks )
Standard dosing is 1 mcg / kg of human body per one injection (100mcg per injection)
Better to start with lower dosing, about 50mcg/inj. and slowly increase…
2-3 times / daily , after training,15 minutes before meal and on the evening before sleep
Increases muscles mass
Reduces body fat
Increases hardness of lean muscles
Increases in appetite
Stronger immune system
Improves bone density
Protection liver effect
Healthier skin and hair
POSSIBLE SIDE EFFECTS
As a results of tests there is no many side-effect with GHRP6 cycles.
In higher dosing (600mcg/daily) can be increased concentration of prolactin and cortisol, but much lower then with GHRP2. After injection there is a possibility to feel burning effect at the injection site for 5-10 minutes.
AMOUNT OF WATER TO MIX
Most people will prefer to mix peptide with bacteriostatic water also you can mix it with sterile water or with sterile saline The only thing that will change with the differing amounts of water is the amount you have to inject to get a certain dosage. We recommend mixing 1ml of water per 2mg of peptide.
Make vial temperature same as the room temperature, afterwards mix it smoothly using rotary moves (don’t shake) adding your preferred liquid. Try to not put liquid straight on the powder, better if liquid will flow through the walls of the vial.
Store at 2° to 8°C after reconstitution max. 30-35 days ( avoid excessive heat )
To find more information, please check instruction.
BEST COMBINED WITH
The best choice to combine GHRP6 is CJC1295, but you can also mix it with GHRP2 and others stimulators of growth hormone like arginine, GABA and glutamine.